TDC 131 Meat Identification And Fabriction Week 3 Report 1
Meat Identification and Fabrication
Date : 9 October 2017
Name : Muhammad Nur Iman Bin Abdul Razak
ID : 00000102367
INTRODUCTION
9 October 2017 on Monday, we gathered at 7.30 a.m in front of the Culinary Suite 2. After that, Chef Khairul Azmi inspect our uniform to make sure our uniform is complete and clean. Then, the Chef let us enter the kitchen. Before the class start, we bring out our equipment. It was chef knife and paring knife . Before we start the class we wash our hands and each of us enter our on group respectively. We sharpened our knife with Butcher Steel.
CONTENTS
. We begin our class with prepare bring out the meat from freezer.
. Chef Khairul show us how to skinless the meat by using paring knife.
Date : 9 October 2017
Name : Muhammad Nur Iman Bin Abdul Razak
ID : 00000102367
INTRODUCTION
9 October 2017 on Monday, we gathered at 7.30 a.m in front of the Culinary Suite 2. After that, Chef Khairul Azmi inspect our uniform to make sure our uniform is complete and clean. Then, the Chef let us enter the kitchen. Before the class start, we bring out our equipment. It was chef knife and paring knife . Before we start the class we wash our hands and each of us enter our on group respectively. We sharpened our knife with Butcher Steel.
CONTENTS
. We begin our class with prepare bring out the meat from freezer.
. Chef Khairul show us how to skinless the meat by using paring knife.
. We follow the method that Chef Khairul teach us
. After that Chef show us how the method beef tenderloin
. We follow the method that chef show to us
. Chef also show us basic cutting meat. There was 3 type of basic cutting slice,cube and chop.

. So this is our result cutting of meat and tenderloin

.Conclusion
In a conclusion, we have learn a little bit of basic cutting and meat tenderloin that are useful for our skill.





Comments
Post a Comment